Latest Activity In Study Groups

Join Your Study Groups

VU Past Papers, MCQs and More

We non-commercial site working hard since 2009 to facilitate learning Read More. We can't keep up without your support. Donate.

CS601 Assignment No. 4 Semester Fall 2012 Data Communication Due Date: 29-01-2013 Please share your ideas here

Assignment No. 4
Semester Fall 2012
Data Communication - CS601

 

Total Marks: 30

 

Due Date: 29-01-2013

 

Objective: Understanding the T & E lines and Error detection method.

Instructions:

Please read the following instructions carefully before solving & submitting assignment:

Assignment should be in your own wordings not copied from net, handouts or books.

It should be clear that your assignment will not get any credit (marks) if:

 

  • The assignment is submitted after due date.
  • The submitted assignment does not open or file is corrupt.
  • The assignment is copied (from other student or copied from handouts or internet).

 

For any query about the assignment, contact at cs601@vu.edu.pk

 

GOOD LUCK

 

 

 

Q. 1. Telephone Companies use a hierarchy of Digital Signals Service (DS) which have different levels as DS-0, DS-1, DS-2, DS-3 and DS-4. All these levels have different data rates and are implemented through different types of T lines (from T-1 to T-4) or E lines (from E-1 to E-4) on the basis of data rate in each level.

Now you are required to fill  the columns of the given table according to following  instructions:

  1. Calculate the corresponding data rate against each number of given voice channels.
  2. Write the best suitable type of line (form T-1 to T-4 or from E-1 to E-4 line) with total number of T or E lines corresponding to calculated data rate. [15 Marks]

 

Note: Type of line (form T-1 to T-4 or from E-1 to E-4 line) and total number of T or E lines must be selected on the basis of calculated data rate having minimum wastage of capacity of the line. Only optimal solution is required for these columns.

 

No. of Voice Channels

Data Rate in Mbps

Type of T/E line used

Total No. of T/E lines

50

 

 

 

90

 

 

 

140

 

 

 

195

 

 

 

600

 

 

 

 

 

 

Q. 2.  Using Modulo-2 Division and Polynomial x4 + x3 + x + 1, perform the complete process of Cyclic Redundancy Check (CRC) on the given message by writing all steps for both sender and receiver end.

 Assume that the message has been received by the receiver without any error. [15 Marks]

 

Message:

1010111001100010

 

 

Views: 9878

Attachments:

Replies to This Discussion

asif sahib yeah taheek ha na upload ker dain 

very thx Asif Bhai MCS for improving the assignment 

plz tel me how u find T /E lines are using?And how calculate data rate .what overhead is also added ?plzzzzzzzzzzzzz explain

very good

thank u so much Asif. abhi work itna tha k is assignment par kam krna bht mushkil hota.

Thank you Bro.
I just want take the concept how did you Draw the Division. and seen from your document but i didn't copied.

Once Again Thanx Brother.

nice...correct...and thanksss....

maximum possible data rate on a communication channel
data rate - in bits per second
bandwidth - in cycles per second or Hertz
noise - on communication link
error rate - of corrupted bits

New Announcement

Instruction about Assignment No.4

Dated: Jan 24, 13

Dear Students, 

In assignment no. 4, while selecting T or E lines, there is no need to include any overhead in the table although we have used it in handouts but you are not required to include it.  You are just required to select T or E lines on the basis of calculated data rate (without including overhead).

 

Regards

CS601 4th Assignment solution Due Date: 29-01-2013

CS601 4th Assignment solution Due Date: 29-01-2013

Q. 1. Telephone Companies use a hierarchy of Digital Signals Service (DS) which have different levels as DS-0, DS-1, DS-2, DS-3 and DS-4. All these levels have different data rates and are implemented through different types of T lines (from T-1 to T-4) or E lines (from E-1 to E-4) on the basis of data rate in each level.
Now you are required to fill the columns of the given table according to following instructions:
Calculate the corresponding data rate against each number of given voice channels.
Write the best suitable type of line (form T-1 to T-4 or from E-1 to E-4 line) with total number of T or E lines corresponding to calculated data rate. [15 Marks]

solution

DS0
64Kbps
1/24 of T-1
1 Channel


DS1
1.544Mbps
1 T-1
24 Channels


DS1C
3.152 Mbps
2 T-1
48 Channels


DS2
6.312 Mbps
4 T-1
96 Channels


DS3
44.736 Mbps
28 T-1
672 Channels


DS3C
89.472 Mbps
56 T-1
1344 Channels


DS4
274.176 Mbps
168 T-1
4032 Channels



Q. 2. Using Modulo-2 Division and Polynomial x4 + x3 + x + 1, perform the complete process of Cyclic Redundancy Check (CRC) on the given message by writing all steps for both sender and receiver end.
Assume that the message has been received by the receiver without any error. [15 Marks]

 

data rate find kerny k steps kya hongy?

Steps for Data Rate Calculation:

  1. One voice channel data rate is 64kbps.
  2. so if we have 50 channels like in assignment then 50x64 kbps=3200kbps
  3. we need date rate in Mbps so 3200kbps/1000= 3.2Mbps

So in this way you can calculate Data Rates.

RSS

Looking For Something? Search Below

VIP Member Badge & Others

How to Get This Badge at Your Profile DP

------------------------------------

Management: Admins ::: Moderators

Other Awards Badges List Moderators Group

© 2021   Created by + M.Tariq Malik.   Powered by

Promote Us  |  Report an Issue  |  Privacy Policy  |  Terms of Service