Latest Activity In Study Groups

Join Your Study Groups

VU Past Papers, MCQs and More

We non-commercial site working hard since 2009 to facilitate learning Read More. We can't keep up without your support. Donate.

Assignment No 3 Data communication (CS601) Solution and Discussion Spring 2014 Due Date: July 14, 2014

Uploading instructions:

  • Your assignment must be in .doc format. (Any other formats like scan images, PDF, Zip, rar, bmp, etc will not be accepted).
  • Save your assignment with your ID (e.g. bc020200786.doc).
  • No assignment will be accepted through email.

Rules for Marking:

It should be clear that your assignment will not get any credit if:

  • The assignment is submitted after due date.
  • The submitted assignment does not open or file is corrupted.
  • Your assignment is copied from internet, handouts or from any other student 
  • (Strict disciplinary action will be taken in this case).


Question 1: (5 Marks)
When a signal travels from source to destination, it may b affected by different external factors that cause the loss of energy, due to which the signal may differs from its actual shape. In the given table you are required to identify the type of noise with respect to noise source.

Noise Source                                                             Noise Type

Telephone Wire
Water Pump
Extra Signal generated by Motion of Electron

Question 2: (5 Marks)
Suppose a signal is generated from a source with initial power of 1000W but due to attenuation it is received at destination (80 Km away from source) with power of 100W. Find the total power loss in decibels by writing formula with all calculation steps.

Question 3: (5 Marks)
Suppose you need to have simultaneous transmission of signals through a single medium, then which technique will be used to fulfill this requirement? Also describe, how does that technique work at sender and receiver end?

NOTE: Do not put any query on MDB about this assignment, if you have any query then email at

Deadline: Your assignment must be uploaded/submitted on or before 14th July 2014.

Views: 16227


Replies to This Discussion

ye kia?

ye to sirf atenuation ha 

power loss kese nikalna ha

Q# 2 main p2 or p1 watt main han ...........kya in dono ko db main convert kerna hai?

Noise Source Noise Type
Telephone Wire Crosstalk
Water Pump Industrial Noise
Earthquake Seismic Noise
Extra Signal generated by Motion of Electron Thermal Noise
Grinder Industrial Noise


3rd question solution plz 

frnds muja ya samj nai aa rha k first part ma ap logo na industrial noise or dusri type of noise ke bat ki ha aus ka book ma koi zikar nai ha........ to pher ya kha sa aa gai.... 

Multiplexing is a set of techniques that allows the simultaneous transmission of multiple signals across a single data link”

When we are using multiplexing technique we need to have MUX at the sender side, which combine multiple TX streams into single stream and DEMUX at the receiver side, which separates stream back into its component transmissions and directs them into their intended devices.

make me currect if i wrong

question # 2 main p2 or p1 watt main han..... kya inko dbs main convert kerna hai???????????????????????????


Looking For Something? Search Below

VIP Member Badge & Others

How to Get This Badge at Your Profile DP


Management: Admins ::: Moderators

Other Awards Badges List Moderators Group

© 2021   Created by + M.Tariq Malik.   Powered by

Promote Us  |  Report an Issue  |  Privacy Policy  |  Terms of Service