Latest Activity In Study Groups

Join Your Study Groups

VU Past Papers, MCQs and More

We non-commercial site working hard since 2009 to facilitate learning Read More. We can't keep up without your support. Donate.

CS601 Data Communication GDB Fall 2020 Solution / Discussion

Views: 932

Replies to This Discussion

CS601 GDB Fall 2020 solution idea:

 

Networks Use Congestion

Control and congestion avoidance techniques to try to avoid collapse. These include: exponential back off in protocols such as window reduction in KT% and fair queuing in devices such as routers and network switches.

 

 

Congestion Control

congestion control is the best when it comes to the routers since is the best technique that best address congestion and the priory scheme that allows higher transmission of packets from busy devices like routers. Since the protocols such as CSMA/CA in 802.11 and the CSMA/CD in the original Ethernet and fair queuing in devices is efficient and the explicit allocation of network resources to specific flows through the use of admission control.

Share the GDB Question & Discuss Here....         

Stay touched with this discussion, Solution idea will be uploaded as soon as possible in replies here before the due date.

CS601 GDB Solution Fall 2020 - 2021 || Data Communication ||

Question

Total Marks 5
Starting Date Monday, February 15, 2021
Closing Date Tuesday, February 16, 2021
Status Open
Question Title GDB
Question Description

Dear Students,

            GDB of CS601 is announced on VULMS. GDB would be opened for two days i.e. 15 February, 2021 (Monday) - 16 February, 2021 (Tuesday) to submit your answers / responses. Submit your answers on mentioned dates as no GDB would be accepted via email. GDB scenario is provided below:

GDB Scenario:

          Congestion in a network may occur if the load on the network is greater than the capacity of the network. The congestion control scheme tries to bring the network back to an operating state, while a congestion avoidance scheme tries to keep the network at an optimal state. The instant at which a congestion control scheme is called, depends on the amount of memory available in the routers whereas, the point at which a congestion avoidance scheme is invoked, is independent of the memory size. A congestion avoidance scheme may continuously oscillate slightly around its goal without significant degradation in performance. However, the congestion control scheme tries to minimize the chances of going above the limit.

 

As a network administrator, in your opinion, which of following technique will be more suitable for a WAN?

  1. Congestion Avoidance
  2. Congestion Control

Justify your answer with at least 3 valid reasons.

Note: A concise, coherent and to the point comment is preferred over lengthy comment having irrelevant details. Your comment must not be more than 4-5 lines. Comments, posted on regular Lesson’s MDB or sent through email will NOT be considered in any case.

#cs601gdb1solutoinfall2021 #cs01gdbsolution2021
CS601 GDB 1 Solution Fall 2021 | CS601 GDB Solution 2021

CS601 GDB 1 Fall 2020/2021

cs601 gdb solution 2021. GDB  would be opened for 2 days i.e. fifteen Feb, 2021 (Monday) -16 Feb, 2021 (Tuesday) to submit your answers / responses. Submit your answers on mentioned dates as no GDB would be accepted via email. GDB state of affairs is provided below:

GDB Scenario:

Congestion in an exceedingly network might occur if the load on the network is larger than the capability of the network. The congestion management theme tries to bring the network back to an in operation state, whereas a congestion rejection theme tries to stay the network at associate best state.

 

The moment at that a congestion management theme is termed, depends on the amount of memory accessible within the routers whereas, the purpose at that a congestion rejection theme is invoked, is freelance of the memory size. A congestion rejection scheme might ceaselessly oscillate slightly around its goal while not vital degradation in performance. However, the congestion management theme tries to reduce the possibilities of going higher than the limit.

 

As a network administrator, which of following technique will be more suitable for a WAN? write your opinion?

(1) Congestion Avoidance

(2) Congestion Control

Justify your answer with at least 3 valid reasons.

Note:

A concise, coherent and to the purpose comment is most well-liked over extended comment having unsuitable details. Your comment should not be over 4-5 lines.. Comments, posted on regular

Lesson” s MDB or sent through email will NOT be considered in any case.

If you would not mention your choice(s) at start of your answer then it may affect your marks.

IDEASOLUTIOON

Too several packets gift during a a part of the network causes packet delay and loss that degrades performance, this case is named congestion. In my Opinion Congestion control technique is best. Congestion management refers to techniques and mechanisms which will either forestall or take away congestion

The main objective of the congestion control is to minimize the delay and buffer overflow caused by network congestion and hence enable the network to perform better. In wired networks, Congestion management largely applies to the packet-switching networks.

However, such congestion management techniques don’t apply on to circumstantial networks, that involve special challenges like restricted wireless information measure, power constraints, and route failures because of node quality and restricted buffer size.

The most effective way to control congestion is to reduce the load that the transparent layer is placing on the network. Congestion control mostly applies to the packet-switching networks.

DOWNLOAD SOLUTION FILE OF cs601 gdb solution 2021 FROM LINK BELOW:

Complete Solution of CS601 GDB Fall 2020, CS601 GDB 1 Solution Fall 2021, cs601 gdb solution 2020, cs601 gdb solution 2021, cs601 gdb solution 2021 forstudy.info, CS601 GDB Solution Fall 2020 - 2021

CS601 GDB 1 Fall 2020/2021

 

GDB would be opened for two days i.e. 15 February, 2021 (Monday) -16 February, 2021 (Tuesday) to submit your answers / responses. Submit your answers on mentioned dates as no

GDB would be accepted via email. GDB scenario is provided below:

GDB Scenario:

Congestion in a network may occur if the load on the network is greater than the capacity of the network. The congestion control scheme tries to bring the network back to

an operating state, while a congestion avoidance scheme tries to keep the network at an optimal state. The instant at which a congestion control scheme is called, depends on the

amount of memory available in the routers whereas, the point at which a congestion avoidance scheme is invoked, is independent of the memory size. A congestion avoidance

scheme may continuously oscillate slightly around its goal without significant degradation in performance. However, the congestion control scheme tries to minimize the chances of

going above the limit.

As a network administrator, in your opinion, which of following technique will be more suitable for a WAN?

(1) Congestion Avoidance

(2) Congestion Control

Justify your answer with at least 3 valid reasons.

Note:

A concise, coherent and to the point comment is preferred over lengthy comment having irrelevant details. Your comment must not be more than 4-5 lines. Comments, posted on regular

Lesson'' s MDB or sent through email will NOT be considered in any case.

If you would not mention your choice(s) at start of your answer then it may affect your marks.

SOLUTIOON

 

Too many packets present in a part of the network causes packet delay and loss that degrades performance, this situation is called congestion. I

In my Opinion Congestion control technique is best. Congestion Control refers to techniques and

mechanisms that can either prevent or remove congestion . The main objective of the congestion control is to minimize the delay and buffer overflow caused by network congestion and hence enable the network

to perform better. In wired networks, congestion control is implemented at the transport layer and is often designed separately from the functions of other layers. However, such congestion control

techniques do not apply directly to ad hoc networks, which involve special challenges like limited wireless bandwidth, power constraints, and route failures due to node mobility and limited buffer size.

The most effective way to control congestion is to reduce the load that the transparent layer is placing on the network. Congestion control mostly applies to the packet-switching networks.

 

 

SOLUTIOON

 

Too many packets present in a part of the network causes packet delay and loss that degrades performance, this situation is called congestion. I

In my Opinion Congestion control technique is best. Congestion Control refers to techniques and

mechanisms that can either prevent or remove congestion . The main objective of the congestion control is to minimize the delay and buffer overflow caused by network congestion and hence enable the network

to perform better. In wired networks, congestion control is implemented at the transport layer and is often designed separately from the functions of other layers. However, such congestion control

techniques do not apply directly to ad hoc networks, which involve special challenges like limited wireless bandwidth, power constraints, and route failures due to node mobility and limited buffer size.

The most effective way to control congestion is to reduce the load that the transparent layer is placing on the network. Congestion control mostly applies to the packet-switching networks.

 

CS601 GDB 1 Fall 2020 solution idea:

 

GDB would be opened for two days i.e. 15 February, 2021 (Monday) -16 February, 2021 (Tuesday) to submit your answers / responses. Submit your answers on mentioned dates as no

GDB would be accepted via email. GDB scenario is provided below:

GDB Scenario:

Congestion in a network may occur if the load on the network is greater than the capacity of the network. The congestion control scheme tries to bring the network back to an operating state, while a congestion avoidance scheme tries to keep the network at an optimal state. The instant at which a congestion control scheme is called, depends on the amount of memory available in the routers whereas, the point at which a congestion avoidance scheme is invoked, is independent of the memory size. A congestion avoidance scheme may continuously oscillate slightly around its goal without significant degradation in performance. However, the congestion control scheme tries to minimize the chances of going above the limit.

As a network administrator, in your opinion, which of following technique will be more suitable for a WAN?

  1. Congestion Avoidance
  2. Congestion Control

Justify your answer with at least 3 valid reasons.

Note:

A concise, coherent and to the point comment is preferred over lengthy comment having irrelevant details. Your comment must not be more than 4-5 lines. Comments, posted on regular Lesson'' s MDB or sent through email will NOT be considered in any case.

If you would not mention your choice(s) at start of your answer then it may affect your marks.

 

SOLUTION:

Too many packets present in a part of the network causes packet delay and loss that degrades performance, this situation is called congestion. I In my Opinion Congestion control technique is best. Congestion Control refers to techniques and mechanisms that can either prevent or remove congestion . The main objective of the congestion control is to minimize the delay and buffer overflow caused by network congestion and hence enable the network to perform better. In wired networks, congestion control is implemented at the transport layer and is often designed separately from the functions of other layers. However, such congestion control techniques do not apply directly to ad hoc networks, which involve special challenges like limited wireless bandwidth, power constraints, and route failures due to node mobility and limited buffer size.

The most effective way to control congestion is to reduce the load that the transparent layer is placing on the network. Congestion control mostly applies to the packet-switching networks.

cs601GDB solution 2021

Question Title :GDB
Question Description: Dear Students,
GDB of CS601 is announced on VULMS. GDB would be opened for two days i.e. 15 February, 2021 (Monday) - 16 February, 2021 (Tuesday) to submit your answers / responses. Submit your answers on mentioned dates as no GDB would be accepted via email. GDB scenario is provided below:
GDB Scenario:
Congestion in a network may occur if the load on the network is greater than the capacity of the network. The congestion control scheme tries to bring the network back to an operating state, while a congestion avoidance scheme tries to keep the network at an optimal state. The instant at which a congestion control scheme is called, depends on the amount of memory available in the routers whereas, the point at which a congestion avoidance scheme is invoked, is independent of the memory size. A congestion avoidance scheme may continuously oscillate slightly around its goal without significant degradation in performance. However, the congestion control scheme tries to minimize the chances of going above the limit.
As a network administrator, in your opinion, which of following technique will be more suitable for a WAN?
Congestion Avoidance
Congestion Control
Justify your answer with at least 3 valid reasons.
Note: A concise, coherent and to the point comment is preferred over lengthy comment having irrelevant details. Your comment must not be more than 4-5 lines. Comments, posted on regular Lesson’s MDB or sent through email will NOT be considered in any case.

CS601 GDB Solution 2021

RSS

Looking For Something? Search Below

Latest Activity

VIP Member Badge & Others

How to Get This Badge at Your Profile DP

------------------------------------

Management: Admins ::: Moderators

Other Awards Badges List Moderators Group

© 2021   Created by + M.Tariq Malik.   Powered by

Promote Us  |  Report an Issue  |  Privacy Policy  |  Terms of Service