We have been working very hard since 2009 to facilitate in your learning Read More. We can't keep up without your support. Donate Now.

www.bit.ly/vucodes

+ Link For Assignments, GDBs & Online Quizzes Solution

www.bit.ly/papersvu

+ Link For Past Papers, Solved MCQs, Short Notes & More

Looking For Something at Site? Search Below

Assignment No. 02 (GRADED) Semester: Fall 2013 CS609: System Programming-Due Date: 9/12/2013

Assignment No. 02
Semester: Fall 2013
System Programming-CS609

 

Total Marks: 20

 

Due Date: 09/Dec/2013

Graded Assignment

Instructions:                          

Please read the following instructions carefully before submitting assignment:

 

  • You will submit your assignment before or on due date on VU-LMS.
  • Assignment should be completed by your own efforts it should not be copied from internet, handouts or books.
  • You should submit your .doc File via assignment interface at VU-LMS.
  • Assignment sent via Email will not be replied and accepted in any case.
  • If the submitted assignment does not open or file is corrupt, it will not be marked.
  • You will submit solution only in document (.doc or .docx) File.

 

Objectives:

 

To understand the use of ISR and its services.

 

 

For any query about the assignment, contact at cs609@vu.edu.pk

Assignment Questions

 

Question 1:                                                                                                                               Marks 10     

Question 1:

Serial port contains a special chip for input/output which can communicate in two different modes. Explore and describe these modes and which one is better in the serial communication.

Note: Solutions containing the image of any text will reward zero marks.

Question 2:                                                                                                                               Marks 04     

Data is written at UART internal Transmitter Holding Register. What do you think is the role of Transmit Shift Register and TxD line during this write operation?

 

Question 3:                                                                                                                               Marks 06     

DTE wants to communicate with the DCE using RS232C Protocol. How does this communication start and end?  Identify the steps involved from the starting signal to ending signal between DTE and DCE device.

 

BEST OF LUCK


+ http://bit.ly/vucodes (Link for Assignments, GDBs & Online Quizzes Solution)

+ http://bit.ly/papersvu (Link for Past Papers, Solved MCQs, Short Notes & More)

+ Click Here to Search (Looking For something at vustudents.ning.com?)

+ Click Here To Join (Our facebook study Group)


Views: 5361

Attachments:

Replies to This Discussion

sir,
Serial port contains a special chip for input/output which can communicate in two different modes. Explore and describe these modes and which one is better in the serial communication.
my question is about the question#1 of assignment #2 ..kindly guide me about the given statement are we write about the serial communication modes which are asynchronous and synchronous ???or we have write about special chip which is  UART chip and it modes
 
regards!
Post Your Comments
Other Students' Comments: 0

Instructor's Reply:
Read the question carefully. You have been asked about the modes of special chip not the modes of serial communication. Think on it, and find the answer. (very easy if you know about that chip)


Read more at http://vustudents.ning.com/forum/topics/assignment-no-02-graded-sem...

The difference between Asynchronous and Synchronous is that Synchronous is the more efficient method of PC communication. However Asynchronous is the most common method of communication used for email applications, internet access and networking. Synchronous is usually used for transmission of large data bocks.

JazakAllah asim 

anyone plz tell me which mode is better for serial communication?

Asynchronous!

plz discuss about q2 & q3 as well!

Asynchronous or synchronous? 

Two modes:
1. 25-pin D-type connector (DB-25)
2. 9-pin D-type connector (DB-9)

ye to uart k hen or mere kheyaal me uart is the input/output chip that is used by serial port.

 yar i am in confusion plzz clear it

UART is attached with computer and perform serial communication

Modem attached with UART using RS232C

. RS-232 standard supports two types of connectors’ 25-pin D-type connector (DB-25) and a 9 pin D type connector (DB-9).

There are two modes that serial chip used for input/output operation


1. 25-pin D-type connector (DB-25)
2. 9-pin D-type connector (DB-9)

I think they are type of connectors not modes. Modes might be Asynchronous or synchronous.

yr lms man problem a rha ha kal grace tha assignment ka kia ho ga aj b error ha open nai ho rha ha ub kia ho ga expire ho jay ge????????//

RSS

Latest Activity

Profile Iconsam faisal, Heena Muneer, daniyal ahmed and 19 more joined Virtual University of Pakistan
21 minutes ago
Mani Siddiqui Ex posted a status
""_عورت بیوی ہو, بہن ہو, دوست ہو یا بیٹی اس میں ماں جیسا خیال رکھنے کی خصوصیات ہوتی ہیں_""
39 minutes ago
Tasha Malik posted a status
"Eng301 GDB 1, complete and accurate idea solution https://youtu.be/NMckVig0OVs"
1 hour ago
+M.Tariq Malik replied to Fragrance of Islam's discussion ENG301 Business Communication GDB No 01 Fall 2020 Solution / Discussion in the group ENG301 Business Communication
10 hours ago
+!!! ❤️ Shadow Girl❤️!!! replied to Miss. Churhail's discussion $$$$$AB YE SOCHA HY K HAM HAD SE GUZAR JAYEN GY$$$$$$
10 hours ago
maha replied to +M.Tariq Malik's discussion Mid Term Quiz Will Be Conducted Instead Of Mid Term Examinations - Fall 2020 Semester
10 hours ago
+!!! ❤️ Shadow Girl❤️!!! liked Miss. Churhail's discussion $$$$$AB YE SOCHA HY K HAM HAD SE GUZAR JAYEN GY$$$$$$
10 hours ago
maha replied to +M.Tariq Malik's discussion Mid Term Quiz Will Be Conducted Instead Of Mid Term Examinations - Fall 2020 Semester
10 hours ago
+M.Tariq Malik replied to +M.Tariq Malik's discussion FIN630 GDB No 01 Fall 2020 Solution / Discussion Last Date: 27-11-2020 in the group FIN630 Investment Analysis & Portfolio Management
10 hours ago
Aasma kiran commented on +M.Tariq Malik's group ENG301 Business Communication
10 hours ago
Aasma kiran joined +M.Tariq Malik's group
10 hours ago
+M.Tariq Malik replied to +M.Tariq Malik's discussion CS602 Computer Graphics Assignment 01 Fall 2020 Solution / Discussion Due Date: 04-12-2020 in the group CS602 Computer Graphics
10 hours ago
+M.Tariq Malik replied to +M.Tariq Malik's discussion CS602 Computer Graphics Assignment 01 Fall 2020 Solution / Discussion Due Date: 04-12-2020 in the group CS602 Computer Graphics
10 hours ago
+M.Tariq Malik replied to +M.Tariq Malik's discussion CS602 Computer Graphics Assignment 01 Fall 2020 Solution / Discussion Due Date: 04-12-2020 in the group CS602 Computer Graphics
10 hours ago
Rabbani King updated their profile
10 hours ago
Tahir Ali left a comment for sara khan
10 hours ago

© 2020   Created by +M.Tariq Malik.   Powered by

Promote Us  |  Report an Issue  |  Privacy Policy  |  Terms of Service

.