Assignment # 6 CS609 has been uploaded. Its due date is 06 -02- 2013. Please discuss here about the assignment
Please read the following instructions carefully before submitting assignment:
It should be clear that your assignment will not get any credit if:
The objective of this assignment is to enhance your knowledge about;
What advantage and disadvantage do we get if Bytes per Sector used in a file system is too small/large? Your answer shall be in the following tabular format.
No. of Bytes per Sector is Small
No. of Bytes per Sector is Large
Let suppose we have to store files on a hard disk having sizes given as below.
840 Bytes, 1790 Bytes, 650 Bytes, 2470 Bytes and 2840 Bytes.
You have to choose an optimal size of sector on your disk which also referred as Bytes per Sector or Block Size. You have the choice to choose the Sector size only from typical values 512 Bytes, 1024 Bytes or 2048 Bytes. Do not make random guess, do some calculations and report them in your solution. Based on your calculations, answer the following questions with reasons stated briefly.
Question No.1: What Block size will you choose if the objective is to have optimal disk space utilization?
Question No.2: What Block size will you choose if the objective is to have reduced access time?
You are required to submit a single MS word file through LMS.
thora boht idea he de do
sana sis paper abhe kahan start hoe hain is sbject mai koi help nhi krta or help sirf isi mai chahy hoti hai ...:/
is subject ki koi help nai krta. even k mere jannay walay bi.
kinu dil da haal sunawan??????????????????????
koi mehram raaz na milda
koi Allah ka banda koi hints he de do kahan se ha yeh assignment
any one alive here for help
give some idea plz
plzzzzzzz any 1 hlpppp us
nai koi nahi hy jo idea dy aaj extended day hy waisy bhi :(
koi help kesy kry sub papro ki tayri mai busy hainnnnnnnnnnnnnnnnnnnnnn
Itr is really a tough assignment, no clue
Anyway, here is few word from Wikipedia....
A sector is the smallest storage unit that is addressable by a hard drive, and all information stored by the hard drive is recorded in sectors.
Floppy disks and controllers use physical sector sizes of 128, 256, 512 and 1024 bytes (e.g., PC/AX), whereby formats with 512 bytes per physical sector became dominant in the 1980s.
The most common physical sector size for harddisks today is 512 bytes, but there have been hard disks with 520 bytes per sector as well for non-IBM compatible machines. In 2005 some Seagate custom hard disks used sector sizes of 1024 bytes per sector. Advanced Format hard disks use 4096 bytes per physical sector (4Kn) since 2010, but will also be able to emulate 512 byte sectors (512e) for a transitional period.
Magneto-optical drives use sector sizes of 512 and 1024 bytes on 5.25-inch drives and 512 and 2048 bytes on 3.5-inch drives.
In CHS addressing the sector numbers always start at 1, there is no sector 0, which can lead to confusion since logical sector addressing schemes (e.g., with LBA, or with "absolute sector addressing" in DOS) typically start counting with 0.
For physical disk geometries the maximal sector number is determined by the low level format of the disk. However, for disk access with the BIOS of IBM-PC compatible machines, the sector number was encoded in six bits, resulting in a maximal number of 63=64-1 sectors per track, where 64=26 corresponds to six bits. The maximum 63 is still in use for virtual CHS geometries.