We have been working very hard since 2009 to facilitate in your learning Read More. We can't keep up without your support. Donate Now.

www.bit.ly/vucodes

+ Link For Assignments, GDBs & Online Quizzes Solution

www.bit.ly/papersvu

+ Link For Past Papers, Solved MCQs, Short Notes & More

Dear Students, Quiz No. 1 of CS609 will be held on December 14, 2015 and will also remain open on December 15, 2015. Lecture no. 1 to 20 will be included in the quiz. You are required to attempt the quiz as early as possible once it is available to you. Best of Luck! Regards,


+ http://bit.ly/vucodes (Link for Assignments, GDBs & Online Quizzes Solution)

+ http://bit.ly/papersvu (Link for Past Papers, Solved MCQs, Short Notes & More)

+ Click Here to Search (Looking For something at vustudents.ning.com?)

+ Click Here To Join (Our facebook study Group)


Views: 4436

Replies to This Discussion

CS609_Fellow's Latest Quizz
5:15pm,15 Dec 2015
1_ What is output of the following program; #include<DOS.H> union REGS regs; void main (void ) { regs.h.al = 0x99; regs.h.ah = 0x00; printf ("%x",regs.x.ax); }
9900
 
2_ At IRQ 7 Interrupt # ___ is used.
0x0F  pg 95
 
 
3_ _________ is a device incorporated into the PC to update time even if the computer is off.
Real time clock  pg136
 
4_ In self test mode the output of the UART is routed to its input.
TRUE pg117
 
 
5_ Interrupt ______ is used to get or set the time.
1AH 
 
6_ if the following function, keep(1, 1000); is called in the TSR program, it means that ________ No. of bytes are reserved in the memory.
16000  lec03
 
7_  In interrupt vector table, if we are at address 0000:03FBH, this represent interrupt number;
FF (not conform)
 
8_ The baud rate is set in accordance with the divisor value loaded within the UART internal registers base +0 and base +1.
TRUE pg114
 
9_ Int _______ service 0 can be used to set the line parameter of the UART or COM port.
14H  pg 119
 
 
10_ Maximum numbers of interrupts that are registered in IVT are;
AE (not conform)

CS609_Mine Latest Quizz

4:47pm, 15 Dec 2015

1_ There are differences in mechanism of invocation of interrupt and event driven procedures.
No
 
 
2_ The ________ function simply enables the self test facility within the modem control register.
SelfTestOn() lec16
 
 
3_ If we are at address F000:0000H, then we are supposed to invoke interrupt(s) for;
BIOS (not sure)
4_ In case of synchronous communication a timing signal is required to identify the start and end of a bit.
false (not conform)
 
 
5_ Interrupt number 8 is invoked by ____________.
Hardware
 
 
6_ ______ is used to set time.
1A/03H pg138
 
 
7_ The ______ service # is not used in any interrupt.
FF lec 02
 
 
8_ The memory addresses of COM ports remain same for all computers.
FALSE  lec 14
 
 
9_ In self test mode the output of the UART is routed to its input.
True pg117
 
 
10_Interrupt ______ is used to get or set the time.
1AH 

Some Quizz files,

Attachments:

thanks u helped a lot

Khush Rahein dear.. 

more..

Attachments:

Quizz+MCQs..

Attachments:

Be blessed.

RSS

© 2020   Created by +M.Tariq Malik.   Powered by

Promote Us  |  Report an Issue  |  Privacy Policy  |  Terms of Service

.